LS1IMPULSE

iTrader: (42)

I am getting ready to place and order for the Patriot 243's unmilled with the stock valves, and a TR T-rak cam but is there anyone here that knows if this setup will work with NO p2v clearance issues? Also what head gasket should I purchase with it?

Thanks, Matt

erikthegoalie

iTrader: (29)

I am pretty sure on a stock casting unmilled head that it will work fine...guys generally have to flycut when milling is involved, or larger valves are used on certain set ups..
Ask the vendor, thats always the safest bet!
e

2000TransAmWS6

iTrader: (12)

i imagine that Gunnar will tell you that there probably will not be any P2V issues, but to check during your installation anyway.

slow trap

iTrader: (22)

it would be nice if you could use some thinner gaskets without any ptv problems.

LS1IMPULSE

iTrader: (42)

yeah i was hoping to be able to use somthign a little thinner but i cant afford to run into any p2v issues right now

orangeapeel

iTrader: (18)

You might have room to have a cleanup mill done as well. .005 if you had to in the future.