LS3 W LS1 knock's and TSP 1-7/8 header clearance.
#1
LS3 W LS1 knock's and TSP 1-7/8 header clearance.
LS3 about to go into my 01 TA with TSP 1-7/8 LT's. I am planning on drilling the block in the factory LS3 knock sensor locations to install the LS1 knock sensors.
Can someone who has done this on their own car verify the LS1 knock sensors will clear the headers and all other parts when located in the stock LS3 sensor locations.
Can someone who has done this on their own car verify the LS1 knock sensors will clear the headers and all other parts when located in the stock LS3 sensor locations.
#4
The only "problem" I had with mine was the driver side header was super close to the k member on the outside edge, so I just took an angle grinder and buzzed the edge down on the k member. Fits like a glove now.