rebuilt 347 with blow by issues
#1
rebuilt 347 with blow by issues
Hi guys I have a fully rebuilt 347 ls1 hears what been done to it.
block was bored to make a 347
stock crank
H beem rods
mahle pistons
comp cam thumper
comp cam push rods, lifters. 1.72 roller rockers
fast as cast trick flow heads
FAST 92 inlet and TB
car was run in and turned on dyno made 400hp at the wheels.
now I put a catch can on it and it was catching a lot of oil. so I put a ls6 pcv valley plate on it, no were there as much oil in there but blows the oil fuller cap off on half wot now motor has done 2000ks any one know whats wrong?
block was bored to make a 347
stock crank
H beem rods
mahle pistons
comp cam thumper
comp cam push rods, lifters. 1.72 roller rockers
fast as cast trick flow heads
FAST 92 inlet and TB
car was run in and turned on dyno made 400hp at the wheels.
now I put a catch can on it and it was catching a lot of oil. so I put a ls6 pcv valley plate on it, no were there as much oil in there but blows the oil fuller cap off on half wot now motor has done 2000ks any one know whats wrong?