What else when reinstalling a motor could cause no spark? Any OBDII to OBDI Causes?
10-20-2008, 06:13 PM
#1
12 Second Club
Thread Starter
iTrader: (10)
Join Date: Nov 2007
Location: Tucson, AZ
Posts: 1,094
Likes: 0
Received 0 Likes
on
0 Posts
What else when reinstalling a motor could cause no spark? Any OBDII to OBDI Causes? OK I have another thread but I hopped this one might be a better thread title for what I want to know.
I installed the motor out of a 96 OBDII Camaro into my 94 Firebird that's OBDI. I have replaced the Opti and the ECU (With my new MadZ28 one) and I am getting no spark.
I must have over looked something simple, the IGN fuses are fine, the wires to the opti and such are all connected... what am I missing, what during the install could I have over looked or is there something else when going from OBDII to OBDI I could have missed (I swapped the Knock Sensor on the motor and I have both my 96 ICM and Coil and the 94 ICM and Coil which both worked before and swapping them does not make a difference either).
Please help guys I need to get to work tomorrow.
I installed the motor out of a 96 OBDII Camaro into my 94 Firebird that's OBDI. I have replaced the Opti and the ECU (With my new MadZ28 one) and I am getting no spark.
I must have over looked something simple, the IGN fuses are fine, the wires to the opti and such are all connected... what am I missing, what during the install could I have over looked or is there something else when going from OBDII to OBDI I could have missed (I swapped the Knock Sensor on the motor and I have both my 96 ICM and Coil and the 94 ICM and Coil which both worked before and swapping them does not make a difference either).
Please help guys I need to get to work tomorrow.
