lastcall190

iTrader: (36)

Anyone in north jersey or surrounding areas have any? Kind of need them asap, forgot to order them If not, how is everyone making theirs? I was probably gonna just buy a small piece of sheetmetal, trace, cut, RTV, bolt on if I can't find any. Thanks.

-J

BlackScreaminMachine

iTrader: (17)

Id buy something thick, get a trace and approximate, use a GM AIR gasket and you should be fine. I have a Speed INC and they are thick Aluminum.

outkast6991

iTrader: (34)

you could just have somebody weld the base of the old tubes that your removing and grind them flat. that's what i did

JL ws-6

iTrader: (50)

cut the tubes off and weld a patch over them, then you never have to worry about them ejecting themselves off.