How to clearance 350 for 383 crank
#1
How to clearance 350 for 383 crank
Anybody have any tips or pictures of how to do it. The crank will be a one piece rear main scat with 3.75 stroke and stock 5.7 inch rods and pistons.I have the tools to do it and would like to do it myself. I will have it balanced professionally balanced when done. Its a 97 roller motor if anyone cares.
#2
Staging Lane
Join Date: Nov 2006
Location: Modesto, CA
Posts: 71
Likes: 0
Received 0 Likes
on
0 Posts
I'm not sure you need a guide to do this. You just pre-assemble the engine, and rotate the crank/rods/block checking for clearance. Remove the parts, grind the non-clearing points down, re-pre-assemble and check again.
I believe David Vizard says a paperclip's thickness is good enough.
I believe David Vizard says a paperclip's thickness is good enough.