Bench Tune 5.3??
#1
Launching!
Thread Starter
iTrader: (5)
Join Date: Feb 2004
Location: Mobile, al
Posts: 294
Likes: 0
Received 0 Likes
on
0 Posts
Bench Tune 5.3??
Im just finishing up my frame off rebuild of my 76 vette. Swapping in an lm4 and t56. I have a friend who lives a few hours away that has hp tuners and was gonna give me the rest of his credits so he could tune my ECU. What do I need to bench tune? That way I could just take my ecu up to him. I have the complete wiring harness that speartech re did. What would be the easiest route?
#3
Launching!
Thread Starter
iTrader: (5)
Join Date: Feb 2004
Location: Mobile, al
Posts: 294
Likes: 0
Received 0 Likes
on
0 Posts
Bench harnesses are for when the car isnt available. Well I have the entire engine harness. My harness has an OBDII connector the blue pcm connector and a check engine light.Its out of the car, so couldnt I just put an on/off switch between the power supply and the harness?
#4
Staging Lane
Join Date: Sep 2002
Location: Poplar Bluff MO.
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
hey,hook up batt pos and neg to harnes ,pos to ign wire ,HPTuners to ob2 conector your good to flash, that is how I test harrness and pcm funtions on harnnes i redo for swaps JIM