Generation III External Engine LS1 | LS6 | Bolt-Ons | Intakes | Exhaust | Ignition | Accessories
Sponsored by:
Sponsored by:

mti lid

Thread Tools
 
Search this Thread
 
Old 12-31-2008, 05:15 PM
  #1  
Staging Lane
Thread Starter
iTrader: (16)
 
ethan071891's Avatar
 
Join Date: Sep 2008
Location: Browns Summit NC
Posts: 56
Likes: 0
Received 0 Likes on 0 Posts
Default mti lid



Are they all like this
Old 12-31-2008, 06:02 PM
  #2  
TECH Resident
iTrader: (7)
 
01SuperSport's Avatar
 
Join Date: Jul 2006
Location: San Fernando Valley, CA
Posts: 846
Likes: 0
Received 2 Likes on 2 Posts

Default

No they should just have 2 tabs on each side
Old 12-31-2008, 06:36 PM
  #3  
Staging Lane
Thread Starter
iTrader: (16)
 
ethan071891's Avatar
 
Join Date: Sep 2008
Location: Browns Summit NC
Posts: 56
Likes: 0
Received 0 Likes on 0 Posts
Default

no it does but theres like a big gap on the left side so its not straight across maybe because its two pieces?
Old 01-02-2009, 12:34 AM
  #4  
TECH Fanatic
iTrader: (11)
 
BobDoLe's Avatar
 
Join Date: Jul 2006
Posts: 1,510
Likes: 0
Received 3 Likes on 3 Posts

Default

it looks like a piece is cracked off. its hard to tell without a better picture.

how well does it seal up? if there's a fat hole right there where unfiltered air is getting through, then you got a junk lid and need to send it back.
Old 01-02-2009, 04:25 PM
  #5  
Staging Lane
Thread Starter
iTrader: (16)
 
ethan071891's Avatar
 
Join Date: Sep 2008
Location: Browns Summit NC
Posts: 56
Likes: 0
Received 0 Likes on 0 Posts
Default

its not broke off it looks like they put it together kind of sideways
Old 01-02-2009, 06:25 PM
  #6  
TECH Regular
 
HMERacing's Avatar
 
Join Date: May 2008
Location: Marissa, Il
Posts: 458
Likes: 0
Received 0 Likes on 0 Posts

Default

The pic is crap. They should be plastic welded together. as long as the inside and the opening line up then it should be fine.




All times are GMT -5. The time now is 01:58 AM.