Valve covers for ET heads.
#1
TECH Addict
Thread Starter
iTrader: (6)
Join Date: Jun 2005
Location: Winnipeg, Canada
Posts: 2,210
Likes: 0
Received 0 Likes
on
0 Posts
Valve covers for ET heads.
I am using a set of ET 6 bolt heads on my twin blown 427 LSX setup. What valve covers are being used successfully with these heads?- no leaks, good clearance for the shaft mounted rockers I don't think the duct tape is going to cut it.
#3
TECH Addict
Thread Starter
iTrader: (6)
Join Date: Jun 2005
Location: Winnipeg, Canada
Posts: 2,210
Likes: 0
Received 0 Likes
on
0 Posts
LOL.......There are already plenty of LSx valve covers on the market. I have seen some pics of ET heads on here before where the covers were not identified. Can't seem to find them again. Just want to know which ones work with these heads. I have read that some don't seal properly. Top rail looks a little narrower on these heads.
Couple more pics. There will be 2 throttle bodies when it is done.
Couple more pics. There will be 2 throttle bodies when it is done.
#4