hardasskerry

I was playing around yesterday doing a couple of burnouts and flashing my stall but after I was finished playing around i noticed that my car wouldn't take off right and when i tried to nail it from a dead stop my car didn't do anything it just drove off slow with my foot all the way on the gas. When it was in motion and i tried to nail it the car would do a thing, the rpms would red line or anything and it felt like it was trying to go but something was stoping it. Is this a transmission problem or something else. Can some one help me out with this problem cause idk whats going on cause it stoped after i let my car sit for a couple hours but when i started playing with it again later that night it did it again but stoped once again today. Please can anyone tell me WHAT THE HELL IS GOING ON. If you can help thanks

hardasskerry

any idea's anyone

performabuilt

iTrader: (25)

I would scan for codes sounds like you went into limp mode. If you have a stall you may need some tuning and the code test removed for PO757.

hardasskerry

I a yank ss3600 and my car was tuned by thunder racing my scan tool doesn't show any codes right now but it did say something about solenoid b stuck on or something before but I cleared it and it hasn't cone back on yet

performabuilt

iTrader: (25)

You need to have the test for that code removed or it will be intermitantly returning. IMO it should be done anytime a stall over 2800 is used

hardasskerry

so is it a transmission problem I'm having cause I've been having the stall in the trans and when I went to thunder to get the car tuned for my cam I told them everything I had on my car