noise/vibration At high speed's or in neutral after running the 1/4
04-26-2009, 10:46 PM
#1
11 Second Club
Thread Starter
iTrader: (14)
Join Date: May 2007
Location: Aurora IL
Posts: 1,660
Likes: 0
Received 0 Likes
on
0 Posts
noise/vibration At high speed's or in neutral after running the 1/4 noise/vibration At high speed's or in neutral after running the 1320.
My car has never done this before. Not until last year at the track i launched the car and 2 feet after it broke the torque arm (UMI floor mounted) and sent it up into my floor. well it killed the T/Q arm umi sent a new one to me and the drive shaft didnt look bent but i still had it dyno spun and balanced and new u joints put in as well. the trans is fine and i have a driveline solutions 9 with all the goodie's.
Can anyone shot me there take on this
Rob.
My car has never done this before. Not until last year at the track i launched the car and 2 feet after it broke the torque arm (UMI floor mounted) and sent it up into my floor. well it killed the T/Q arm umi sent a new one to me and the drive shaft didnt look bent but i still had it dyno spun and balanced and new u joints put in as well. the trans is fine and i have a driveline solutions 9 with all the goodie's.
Can anyone shot me there take on this
Rob.
04-27-2009, 02:06 PM
#3
You have burned the ring & pinion up most likely. I did this after 4 passes once last year. It screamed bloody murder and had a I frequency vibe like a vibrating chair. I blamed it on the synthetic oil I was running and vowed to only run std. oil in the future.
04-27-2009, 02:31 PM
#4
11 Second Club
Thread Starter
iTrader: (14)
Join Date: May 2007
Location: Aurora IL
Posts: 1,660
Likes: 0
Received 0 Likes
on
0 Posts
Really what that look like???? i was going to pull it apart tonight. cuz it is what you are talking about or i thing the pinion bearing is bad
