Where to get new 317's?
08-09-2009, 01:24 PM
#1
TECH Resident
Thread Starter
iTrader: (36)
Join Date: Dec 2006
Location: Lafayette, CA
Posts: 985
Likes: 0
Received 0 Likes
on
0 Posts
Where to get new 317's? I have a used set of 317's I was planning to spruce up but after pulling them apart, I think I might be better off just picking a new set. Either the LQ4 or LQ9 versions, 12562317 or 12572035's. I've done some searching on the usual GM parts sites but no luck. Any ideas on where to pick up a new set?
Rick
Rick
Last edited by Rick_Vor; 08-09-2009 at 06:10 PM.
08-09-2009, 04:59 PM
#2
TECH Fanatic
iTrader: (6)
Join Date: Dec 2001
Location: LV NV
Posts: 1,114
Likes: 0
Received 0 Likes
on
0 Posts
I would just opt for Richard at west coast cylinder head to do them. He would probably just send you an already done other set then your actual heads, but you never know.
They are a sponsor.
They are a sponsor.
08-09-2009, 11:56 PM
#3
Ive got a set off of a 2007 6.0, taken off the motor with only 100 miles on them, did a L92 head swap immediately. I can see if the guy who owns them wants to let them go. They are brand new for all means and purposes.
08-10-2009, 08:07 AM
#4
TECH Resident
Thread Starter
iTrader: (36)
Join Date: Dec 2006
Location: Lafayette, CA
Posts: 985
Likes: 0
Received 0 Likes
on
0 Posts
LQ9CHEVELLE Ive got a set off of a 2007 6.0, taken off the motor with only 100 miles on them, did a L92 head swap immediately. I can see if the guy who owns them wants to let them go. They are brand new for all means and purposes.
Thanks, Rick
09-04-2009, 06:12 PM
#6
My 6.0's turned out sick as hell after having them redone, I already had a set of valves out of my 6.0's I had redone with large stainless valves, ported, polished chambers, etc so I replaced the two bad valves. Should work damn good on that boosted 4.8! >=)
