LS1TECH - Camaro and Firebird Forum Discussion

Manual Transmission T56 | T5 | MN12 | Clutches | Hydraulics | Shifters

Reinstalling the hydraulic braided line on T-56..

Thread Tools
 
Search this Thread
 
Old 09-21-2009, 07:24 AM
  #1  
Teching In
Thread Starter
 
rfuller07's Avatar
 
Join Date: Dec 2008
Location: Tempe, AZ
Posts: 34
Likes: 0
Received 0 Likes on 0 Posts
Default Reinstalling the hydraulic braided line on T-56..
Cannot get the line back in to the its spot.
Any hints?
rfuller07 is offline  
Reply Like
Old 09-21-2009, 08:39 AM
  #2  
Launching!
iTrader: (2)
 
Bull's Avatar
 
Join Date: Dec 2005
Location: Amherst, MA
Posts: 254
Likes: 0
Received 1 Like on 1 Post

Default
LS1 or LT1?

I have an LT1, so the only braided line I can think of is the one from master to slave.
Bull is offline  
Reply Like
Old 09-22-2009, 06:46 PM
  #3  
FormerVendor
iTrader: (38)
 
Gen414's Avatar
 
Join Date: Nov 2008
Location: Pearland, TX
Posts: 2,309
Likes: 0
Received 0 Likes on 0 Posts
Default
Originally Posted by rfuller07
Cannot get the line back in to the its spot.
Any hints?


Assuming you are talking about line from MC to slave???

Make sure teh plastic ring around the end, is pulled all the way "out", so not to cause interference.
Gen414 is offline  
Reply Like
Old 09-23-2009, 09:03 AM
  #4  
12 Second Club
iTrader: (98)
 
99ssleeper's Avatar
 
Join Date: Oct 2002
Location: Minnesota
Posts: 2,036
Likes: 0
Received 2 Likes on 1 Post

Default
what i did was open the bleeder a little and the line snapped right in, then retighten. just dont open the bleeder too much.
99ssleeper is offline  
Reply Like
Back to Subforum
Manual Transmission
View Next Unread
B&M Ripper shifter camaro/firebird 6spd




Advanced Search
Quick Reply: Reinstalling the hydraulic braided line on T-56..


Reply Closed Thread Share

All times are GMT -5. The time now is 08:20 AM.