c5z16z

i have a c5z 2004 z16 and when i pay off in (2.5 years) i plan on doing a GMMP LSX 454 with a C6 ZO6 TR-6060 tranny with a MONSTER LEVEL 3 clutch what else would i need to look at to get this set up in my 2004 c5 zo6 trying to get some recomendations on this set up ????? thanks on the imput????????

Silver408z

iTrader: (1)

pretty sure you will have to do some changing for the torque tube and rear end as well. Depending on what heads and intake you use, you are looking at sensors and wiring.

WKMCD

iTrader: (2)

Two and a half years is a very long time. There may be something very different out there by then.

c5z16z

well i am planning on buying it from gm performance parts with the ls7 intake manifold and ls7 as cast heads thats what it comes with from gmperformance parts not OEM fully machined cnc ls7 heads ............... but i was told i can use a tr6060 tranny ..... and i thinking can i use the c6 zo6 rear end torque tube ,tr-6060 tranny , and axle (full rear end of a c6 zo6 just with a different clutch the monster level 3 6 puck)...........

Josh@PremierAutosports

iTrader: (11)

I won't buy it from GMPP. For that $$ you could have something way nastier. Like it was said earlier don't get to stuck on your parts now because so much will change in the next 2 years.

02SSLE

iTrader: (26)

You can pick up the trans ,diff, craddle, and all used for about 5000.00 from a salvage yard. As for motor I wouldn't do the LSX block unless you are going some type of FI. The TR6060 is way over kill for that setup IMO.

JudgeGuns

iTrader: (1)

T 56 rocks!