Gears & Axles - T-56 in SN95 question about length

http://www.strangeengineering.net/catalog/index.html

PAGE : 133

A- 48 5/8"
B - 1/2"

On a T-56 in a 1998 mustang GT being bolted to a Ford 8.8" rear. Any idea what length driveshaft I need?

-Garrett

Two ways here....

Jack your car up and pull the driveshaft if you have one. Run a measurement from the transmission output shaft to the U-joint CENTER of the rear yoke. A driveshaft shop can make you something from that measurement alone. Take about 2 inches off that measurement and you should be close on a center to center measurement.