T-56 in SN95 question about length
#1
On The Tree
Thread Starter
iTrader: (3)
Join Date: Mar 2010
Location: Calgary, Alberta
Posts: 121
Likes: 0
Received 0 Likes
on
0 Posts
T-56 in SN95 question about length
http://www.strangeengineering.net/catalog/index.html
PAGE : 133
A- 48 5/8"
B - 1/2"
On a T-56 in a 1998 mustang GT being bolted to a Ford 8.8" rear. Any idea what length driveshaft I need?
-Garrett
PAGE : 133
A- 48 5/8"
B - 1/2"
On a T-56 in a 1998 mustang GT being bolted to a Ford 8.8" rear. Any idea what length driveshaft I need?
-Garrett
#2
Staging Lane
iTrader: (1)
Join Date: Dec 2009
Location: Fort Worth, TX, USA
Posts: 80
Likes: 0
Received 0 Likes
on
0 Posts
Two ways here....
Jack your car up and pull the driveshaft if you have one. Run a measurement from the transmission output shaft to the U-joint CENTER of the rear yoke. A driveshaft shop can make you something from that measurement alone. Take about 2 inches off that measurement and you should be close on a center to center measurement.
Jack your car up and pull the driveshaft if you have one. Run a measurement from the transmission output shaft to the U-joint CENTER of the rear yoke. A driveshaft shop can make you something from that measurement alone. Take about 2 inches off that measurement and you should be close on a center to center measurement.