throw out bearing and master cylinder questions
#1
Staging Lane
Thread Starter
iTrader: (3)
Join Date: May 2007
Location: Lakeland FL
Posts: 53
Likes: 0
Received 0 Likes
on
0 Posts
throw out bearing and master cylinder questions
Hey everyone, I am trying to make a parts list of things im going to need to put a t56 into my car. Rite now it is a 4spd with a hydraulic throw out bearing. I am using a McLeod t.o.b. and a wilwood 3/4" bore master cylinder. Im trying to see if ill be able to reuse my clutch master cylinder, or if ill have to get a new master when i get the LS style throw out bearing.
My question is either how much volume does an LS style throw out bearing require to operate properly? Or does anyone know the bore of a stock clutch master? Thanks for any pieces to the puzzle
My question is either how much volume does an LS style throw out bearing require to operate properly? Or does anyone know the bore of a stock clutch master? Thanks for any pieces to the puzzle
#2
Staging Lane
Thread Starter
iTrader: (3)
Join Date: May 2007
Location: Lakeland FL
Posts: 53
Likes: 0
Received 0 Likes
on
0 Posts
I did a little bit more research, i can only find one bit of information on summit, it is a Dorman master: DHB-CM350125 They state its a factory replacement and is a 3/4" bore. It doesnt say the stroke, but i guess ill keep looking around but its looking like i can keep the master cylinder i have now but im still looking for more info to be sure...