toyota xrunner ls1 swap help
#1
Teching In
Thread Starter
iTrader: (2)
Join Date: Jan 2010
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
toyota xrunner ls1 swap help
Ok I have a ls1 from a camaro
2005 ssr t56
Corvette 97-04 clutch flywheel combo
Stoxk gm hydraulic throw out bearing square face for a vette
The tob fully compressed is 2.5 inches
From the fingers of the clutch to the Bellhousing is 2 7/16 inches
Mounting spot for tob in tranny to face of tranny surface is 9/16 so around 3 inches total the tob needs to be fully compressed and to just touch the fingers
Problem is tob maxed out is 3.25 inches and the way it is now is allowing it to go to over and leak, my pedal just off the floor would finally touch the fingers. And I know how to bleed it. Wasn't a air pocket problem
Does anyone have measurement of a stock camaro tob fully compressed and so on? Or do I need to have a spacer made? I have been reading for hours and haven't come across this. Please help. Thank you all is love
2005 ssr t56
Corvette 97-04 clutch flywheel combo
Stoxk gm hydraulic throw out bearing square face for a vette
The tob fully compressed is 2.5 inches
From the fingers of the clutch to the Bellhousing is 2 7/16 inches
Mounting spot for tob in tranny to face of tranny surface is 9/16 so around 3 inches total the tob needs to be fully compressed and to just touch the fingers
Problem is tob maxed out is 3.25 inches and the way it is now is allowing it to go to over and leak, my pedal just off the floor would finally touch the fingers. And I know how to bleed it. Wasn't a air pocket problem
Does anyone have measurement of a stock camaro tob fully compressed and so on? Or do I need to have a spacer made? I have been reading for hours and haven't come across this. Please help. Thank you all is love