98pontiacfirehawk

I just wanted to let you guys know, I just got through busting the bubble of a 04 SVT Cobra ***. He was a smart *** anyway he keep coming by wanting to race and I got tired of him reving up so I decided to follow and whip him 4 times at 20, 40, 60, and 60 again by several cars. The slower we would go the worse it was for him on the average 4 car pull at 60 6to 7 at 20 all the time steady pull away. He had a few mods under drive pullies a boost pully for 20 psi, headers O.R X pipe and cold air box, programing. In the end, still no match and I'm happy since I didn't even had to spray him. I should have just to end it fast and wouldn't have to waste any more gas.

IronOutlaw

iTrader: (4)

coo. what are your mods?

98pontiacfirehawk

Standard bore forged internals for spraying 200 plus. The engine is the factory LT4 so the heads are stage 3x ported 215 runners with 2.05 valves 1.60 exhaust factory LT4 intake with porting to match the heads, comp XFI 292 cam if I remember right its .600 lift with the 1.6 rockers, 58 mm throttle body the 52 mm was to small real life difference when swap to 58mm gained 22 hp on the dyno, Hooker tuned long tubes, electric water pump, Crane electronics, 6 speed to modified 8.8 rear. There is a few other mods on the 96 SS but can't remember the rest. Future plans are for a blower or turbo haven't decided yet just happy right now with the 200 shot thinking about going 250.

z_speedfreak

iTrader: (3)

good kill. so what did it put down on the dyno?

nitrous2fast

iTrader: (2)

haha boost pulley for 20psi..... he must not have even had an aftermarket pulley! good kill BTW.

Zlow28

iTrader: (11)

You should've sprayed him to really embarrass him! +1 on dyno numbers