LS1TECH - Camaro and Firebird Forum Discussion

LT1-LT4 Modifications 1993-97 Gen II Small Block V8

3" drive shaft

Thread Tools
 
Search this Thread
 
Old 05-01-2012, 09:11 AM
  #1  
Launching!
Thread Starter
iTrader: (2)
 
bigz28man's Avatar
 
Join Date: Sep 2010
Location: Brick , NJ
Posts: 298
Likes: 0
Received 1 Like on 1 Post
Default 3" drive shaft
Was wondering will I have any issues as far as clearance goes , with going with a 3" in diameter drive shaft?
bigz28man is offline  
Reply Like
Old 05-01-2012, 09:14 AM
  #2  
TECH Senior Member
iTrader: (2)
 
RamAir95TA's Avatar
 
Join Date: May 2005
Location: South Jersey
Posts: 9,467
Likes: 0
Received 6 Likes on 6 Posts

Default
No - none whatsoever.
RamAir95TA is offline  
Reply Like
Old 05-01-2012, 09:19 AM
  #3  
Launching!
Thread Starter
iTrader: (2)
 
bigz28man's Avatar
 
Join Date: Sep 2010
Location: Brick , NJ
Posts: 298
Likes: 0
Received 1 Like on 1 Post
Default
Ok good thanks, I wanted to confirm cause I have a BMR torque arm, and I'm alittle tired of all issues I have had with my build. Thanks again.
bigz28man is offline  
Reply Like
Old 05-01-2012, 11:19 AM
  #4  
11 Second Club
iTrader: (17)
 
AChotrod's Avatar
 
Join Date: Jul 2008
Location: Chicago area
Posts: 9,896
Likes: 0
Received 1 Like on 1 Post
Default
I have 3.5"DS and I had to bend up the DSL to clear it. Other than that fits great.
AChotrod is offline  
Reply Like
Back to Subforum
LT1-LT4 Modifications
View Next Unread
Competition Clutch guys come in, I need advice real quick!




Advanced Search

All times are GMT -5. The time now is 10:59 PM.