Generation IV Internal Engine - Will these work ok !
05-04-2012, 02:28 PM
418 stroker ls2 .030 over .005 in the hole and -11cc dished piston ! Just want to make sure this gasket isnt to wide ?
Head Gasket, 4.160" X 0.030", LS1/LS6 5.7L & LS2 6.0L
05-04-2012, 05:08 PM
I don't see a problem with the bore, but I would be worried about the thickness. We usually try not to run anything thinner then .040" because of quench.
05-05-2012, 12:07 AM
On that note would the -11dish come into play on quench also still .005 in the hole !
05-05-2012, 09:49 AM
.030 gasket would be fine with the piston in the hole. You would end up with .035 quench area.
The dish In the piston has nothing to do with quench area.
vBulletin® v3.7.4, Copyright ©2000-2013, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO