Turbo LS1 dyno estimate...
#1
Turbo LS1 dyno estimate...
Figured i would get a feeler for what to expect..
2000 Trans am, 6 speed, 9 inch
forged 370 CID
stock 317 heads (dual springs etc)
speed inc tu2 cam
LS6 intake/ ported TB
Dual pumps with -8 feed/ -6 return and 80lb injectors
Precision PT76GTS turbo
Kentucky turbo front mount
FMIC setup
dumped downpipe
My waste gate spring is 11 psi, i plan on turning it up to 15-17 psi
whattya' think?
2000 Trans am, 6 speed, 9 inch
forged 370 CID
stock 317 heads (dual springs etc)
speed inc tu2 cam
LS6 intake/ ported TB
Dual pumps with -8 feed/ -6 return and 80lb injectors
Precision PT76GTS turbo
Kentucky turbo front mount
FMIC setup
dumped downpipe
My waste gate spring is 11 psi, i plan on turning it up to 15-17 psi
whattya' think?
#2
TECH Fanatic
iTrader: (12)
Join Date: May 2005
Location: Nashville, TN
Posts: 1,250
Likes: 0
Received 0 Likes
on
0 Posts
mid 600s-700 wheel. Depends on timing/air. What does a PT76GTS run out of steam at? Is that billet wheel?
we did my buddies 370, "boost cam", stock headed, s475 a2w setup a couple months ago. Made 710RWHP on 13psi. This is through a locked 4l80 and dana60 rear with 3.73 gear. It will make 709-710 pull after pull.
I think the s475 with cast wheel is close to running out of steam on us though
we did my buddies 370, "boost cam", stock headed, s475 a2w setup a couple months ago. Made 710RWHP on 13psi. This is through a locked 4l80 and dana60 rear with 3.73 gear. It will make 709-710 pull after pull.
I think the s475 with cast wheel is close to running out of steam on us though