View Full Version : 1994 Trans Am roller trade??


383lt1ta
06-03-2012, 09:51 PM
I want to buy a differnt car so this one has to go. 1994 Trans Am with Currie 9" shorten 3"with 3.70(micro-polished) locker, BMR double adjustable control arms,BMR panhard with brace, BMR sfc, BMR extreme anti roll, UMI tunnel mount torque arm with loop, 3way adj rear shocks, taylor rear battery mount. I also forgot Summit stars with 275/60 MT radials, B&M line lock, abs delete with wilwood proportioning valve, aluminum sumped cell(bolt in factory location). I have lowering springs and ET streets, also.
>
> I just sold the motor and was going to do 6.0turbo setup, but found a malibu I want.
>
> I also have gt4202 76MM turbo and 4l60e built with transbrake.
>
> The dash has two cracks just above center vents, passenger door panel has small crack, headliner is bad(I took out and have). Overall is good for the age.
>
> The paint is okay. The front bumper has stress cracks, one fender has small crack, thats been fixed, but can still see.
>
> I'm asking $3500 OBO for all, except turbo and transmission. Let me know what you think. For specific pictures, give me an email.Thanks, Edward

383lt1ta
06-09-2012, 10:56 PM
offers or trades?

stangeaterz28
06-10-2012, 08:55 PM
Turbo still for sale?

mylilpony71
06-11-2012, 03:32 AM
Where in Missouri are you?

383lt1ta
06-11-2012, 06:14 PM
I'm not selling turbo separate, I'll use it if the car doesn't sell. In Lebanon, 50 miles north of Springfield.

383lt1ta
06-22-2012, 09:31 PM
anybody want to trade plus cash on my end? I want something done, built LS swap, BBC, maybe sbc. Pic of turbo and TIAL bov and hot side piping.

383lt1ta
07-08-2012, 02:34 PM
bump it