Start an exhaust manifold sticky?
#1
Staging Lane
Thread Starter
iTrader: (1)
Join Date: Feb 2006
Location: Carver, MA
Posts: 53
Likes: 0
Received 0 Likes
on
0 Posts
Start an exhaust manifold sticky?
So I was looking at my LM4 out of an Envoy sitting on the engine stand with the factory ex manifolds on it and thought they hugged the block pretty well, both dumping near the bell housing flange pretty close to the block. I also have a set of C5 Vette manifolds I'm hoping will fit my 52 Chevy. I was thinking I should take some pics of the engine with the manifolds, and maybe measure how far away from the block they stuck out at the inlet before I switched manifolds. Then could do the same with the Vette manifolds. If a bunch of guys did this with the different manifolds out there it might help others trying to figure out what would work for their combo. Any input? Already been done somewhere?
Jim
Jim
#2
TECH Resident
There is a post on here somewhere with pics of all the available stock manifolds together. I can't remember if there were measurements included. I have no idea how to find it though....the search tool on this site is pretty worthless
#5
Launching!
Join Date: May 2012
Location: Mobile, Alabama
Posts: 205
Likes: 0
Received 0 Likes
on
0 Posts