rosemont83

Hey guys,

New to the forum but not new to forums..
Hope this is the right section..

Was wondering if I could get some help with this car that I recently picked up..
Its a 2002 Camaro Z28 with 60K on it 6 speed manual..
I used this site to help me change the spark plugs(Seriously, wtf is up with that last plug... I stared at the engine for a good 10 minutes thinking about how the hell I was going to reach it until I admitted defeat and hopped on the internet)

The airbags were deployed from a small hit to the front passenger side.
Very small damage I don't know why the airbags even deployed..

Anyways I got 2 new airbags and a new module and I installed them.
I went to clear the light and its giving a communication error. The seatbelt sensors are ok they know when they are plugged in or unplugged..

I have 2 theories on what's going on..

1. I have to replace an impact sensor on the front that I overlooked.. However looking at alldata and also the almighty google I think that everything is self contained in the module and there is no impact sensor?

2. The module came from a 2000 and my car is a 2002.. The seller said it would work tho.. Could this be the problem?

Thanks for the help guys!

rosemont83

Actually the module came from a 2001 but when it is read by the computer scanner it comes up as a 2000..
The module should still work then..

rosemont83

And one more thing to note..
Its actually a "configuration error" not communication error my bad

LS1Z28

iTrader: (18)

Did you replace the airbag coil in the steering column? There is a discriminating sensor on the core support behind the hood latch that needs to be replaced also. hope this helps.