Thunder Racing coil relocation
#1
TECH Apprentice
Thread Starter
Join Date: Dec 2003
Location: Houston
Posts: 342
Likes: 0
Received 0 Likes
on
0 Posts
Thunder Racing coil relocation
Has anyone used the Thunder Racing coil relocation kit with the Hotchkins strut tower brace installed. As I was looking at the picture of the coils under the front cowling on there website I noticed that our strut brace also goes under the cowling about an inch an a half.
Alan
Alan
Last edited by 1STGEN68-2000SS; 04-19-2004 at 02:43 PM.
#6
TECH Senior Member
iTrader: (9)
Looks alot better now. I have gone through and rerouted the wires so it doesnt look like a spagetti bomb went off on the motor.
Took me one evening to do it. That was taking my time making sure everything was marked correctly. You have to disasemmble your factory coils and then make sure that you keep them matched up per cyl. And getting everything one the JFP kit takes a few minutes. Lots of little pieces that like to fall off as soon as you move your hands or arent paying attention and bump it while you have it on the ground.
Took me one evening to do it. That was taking my time making sure everything was marked correctly. You have to disasemmble your factory coils and then make sure that you keep them matched up per cyl. And getting everything one the JFP kit takes a few minutes. Lots of little pieces that like to fall off as soon as you move your hands or arent paying attention and bump it while you have it on the ground.
#7
TECH Apprentice
Thread Starter
Join Date: Dec 2003
Location: Houston
Posts: 342
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by NataSS Inc
I have the JFP relocation kit with a hotchkis STB. Plenty of room
Alan