Removing switches from door panel
#1
TECH Apprentice
Thread Starter
iTrader: (5)
Join Date: Nov 2001
Location: Lincoln Nebraska
Posts: 320
Likes: 0
Received 0 Likes
on
0 Posts
Removing switches from door panel
Folks,
I'm looking into pulling the switches out of the door window/lock switch panel so I can sand and paint the switch trim panel. I bought an extra set off of Ebay and it looks like the last gay tried with a crow bar. Wondering if there is a trick not to break them. Let me know. Thanks
Tom Zimmerman
I'm looking into pulling the switches out of the door window/lock switch panel so I can sand and paint the switch trim panel. I bought an extra set off of Ebay and it looks like the last gay tried with a crow bar. Wondering if there is a trick not to break them. Let me know. Thanks
Tom Zimmerman
#2
TECH Fanatic
iTrader: (4)
Join Date: May 2002
Location: Locust Fork, AL
Posts: 1,550
Likes: 0
Received 0 Likes
on
0 Posts
just be careful
get a flathead out and pry the trim piece off and the switches are "snapped" into place underneath the piece
but I have seen a few cars with that piece bent a lil on the edge, where people pryed them off
get a flathead out and pry the trim piece off and the switches are "snapped" into place underneath the piece
but I have seen a few cars with that piece bent a lil on the edge, where people pryed them off