TIRED96LT1

iTrader: (1)

Finally got the motor put back together just wanted to share a few brief sound clips for the LT1 crowd. Videos are rather short as there was no cooling system or accessories installed, was just a test start. Hope to have it on the road once the snow dies down in the next few days. Mod list is below!




Stock Short Block - Heads Milled for 11:1 Compression
Ai 200cc Full CNC Porting & Components
Ai Hydraulic Roller Camshaft - Ai 228 / 234 - .614" / .614" - 108 LSA
ARP ProSeries Rocker Studs - 7/16"
Comp Cams Ultra Pro-Magnum Rocker Arms - 1.6 Ratio
GMPP 12499225 Hi-Performance LSx Hydraulic Roller Lifters
Ai One Piece 4130 ChromeMoly Hardened Pushrods 5/16" & .080" Wall Thickness
.026" Head Gaskets
ARP 134-3601 High Performance LTx Cylinder Head Bolt Kit
Full Porting for GM LT Manifold (includes inlet porting)
BBK-1544 Power-Plus Series Throttle Body 58mm
TFS-89036 TrickFlow 36lb/hr Fuel Injector Set
Clear Image Automotive 304 Stainless Gen-II Tri-Y Headers/Export Pipes into Spintech Pro Street 9000's
Meziere HD Electric Water Pump
March Underdrive Pulley
8MM Magnacore Wires/MSD Cap&Rotor with Stock Opti Internals
Cloyes Factory Replacement Timing Set
Walbro 255LPH Pump w/Racetronix Harness
Isky Racing Hardened Chrome-Moly Guide Plates
F-Body 3.5" MAF
95 T56 Trans/ Spec Stage 2+ Clutch / MGW Short Throw Shifter / 3.73 Rear End
PCM Tuned by Alex@PCMPerformance

Thanks For Watching! More to come in spring time.

guppymech

iTrader: (7)

Very NICE, Congrats! With the .026 gaskets you probably alittle higher than 11.0:1. T56....that's cool!

flyinZ

iTrader: (15)

Sounds good. That will be a fun ride

BizZzatch350

iTrader: (33)

Hell yea, sounds great. Awesome to see people build the ol LT1s up instead of swapping them out.

chevy94c

Sounds awesome

93M6Formula

I like that T-56 swap, nice!

bowtienut

iTrader: (1)

Oh No!......you've already ruined it running without an air filter and with open exhaust!
.
.
.

.

.
.

.
.
.

.
.inside joke.....I'm still laughing about some guy giving him hell for that on another forum

Mystery Bird

iTrader: (7)

Nice! That's going to be a fun ride.

TIRED96LT1

iTrader: (1)

Haha! At first I was like oh god...not again. Too funny!




Thanks to everyone for the positive comments I'm very excited to get it on the road this spring for some ET's, dyno numbers and overall beating on the street!

BSmiff

You wife was like, "THANK GOD THIS ***** OVER!!!!"

TIRED96LT1

iTrader: (1)

LMAOO!!!! That was my mother , I had to use her driveway for the project. At the start of the video you can hear her say " You're going to make the neighbors insane" Haha, she was like " can we turn it off now? " " Is it over yet? " "Ok, thats enough now turn it off " ... Too funny.