itsweeks

Category: Engine - Intake/Fuel
Price: $600
Location (State): NV
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LS1/LS6
LS Engine?: Fits LS Engine

I am selling an Edlebrock ls1 intake manifold set-up with billet spacer and throttle body. Also has the factory gaskets. Was going to use for an ls1 build but ended up going with an ls3. Set-up was used maybe 5 times before being taken off a buddies ride. Asking $600 obo. Item is in Las Vegas. Shipping can be discussed. Text Jason at 702-809-8669 or message on here. Thanks

913MOTOR

iTrader: (1)

How does this fit under an Fbody cowl?

itsweeks

i don't know if it does. Was on a sand car.

913MOTOR

iTrader: (1)

Would you be able to supply some measurements for me to check. I have my engine block and heads in the car, would be simple measuring to see,

fastassls1maro

iTrader: (22)

fwiw i have this same setup on my car minus the spacer and the elbow is actually touching the plastic part of the wiper cowl. I dont see it fitting with the spacer installed.