GrandAM cam and support bits
03-13-2003, 10:30 PM
#1
Staging Lane
Thread Starter
Join Date: Jan 2003
Location: Perth, Australia
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
GrandAM cam and support bits Howdy from australia.. i am building up a project car atm.. a 1974 shell but dropping a LS1. Engines in bits at present using a Comaro block with VT commodore other bits.
I want it to rev to 7000rpm or so, and i will hopefully be going for the GrandAM cam as it suits that RPM range. Also been told to go for 918 springs, titanium retainers etc.. what else will be required to run this cam and these rpm's..
I want it to rev to 7000rpm or so, and i will hopefully be going for the GrandAM cam as it suits that RPM range. Also been told to go for 918 springs, titanium retainers etc.. what else will be required to run this cam and these rpm's..
