Brian2001SS

iTrader: (1)

My over the axle pipe on the gmmg is making a noise. How did you guys get up in there to bang it up to stop making noise? The over the axle pipe is kinda in the way. Just thought I would ask before I start trying to bang on the heat shield.

00SS4780

iTrader: (3)

BIG hammer...LOL

WILWAXU

iTrader: (6)

I would try repositioned the exhaust. Keep in mind, that heat shielding is covering your plastic gas tank

frey51

I had a similar problem on my older car, not an fbody, but I just used a hammer and chissle. But be careful.

Brian2001SS

iTrader: (1)

I am thinking about a wedge of wood and pound it between the pipe and shield. Then remove it after i am done of course. I learned on my 82 about the tank above. Never use a srew driver straight up. Put holes in gas tanks....Doh...

00SS4780

iTrader: (3)

How bad is it hitting? My Y-pipe hits the floor some so I have put in a 3/4 rubber hose and it fixed it. Is there any way to try that? Mine is still stock there. Sorry I haven't had to experiance that yet. LOL...

craiG's SS

mine was doing the same thing, and i put it up on a lift, and took a rubber mallet and beat on it a couple times and that dont the job