5.3 heads and MS3
#1
TECH Enthusiast
Thread Starter
iTrader: (2)
Join Date: Oct 2003
Posts: 543
Likes: 0
Received 0 Likes
on
0 Posts
5.3 heads and MS3
I am getting a set of 5.3 heads that have been shaved .006 to clean up the surfaces. I was wondering if a cam along the lines of an MS3 will still clear the pistons with this head.
#3
TECH Enthusiast
Thread Starter
iTrader: (2)
Join Date: Oct 2003
Posts: 543
Likes: 0
Received 0 Likes
on
0 Posts
not sure. I will find out about the valves. I think they may be a little larger than stock. I am not sure about the head gasket yet either. Thats why I am asking questions now, so that when the time comes I have everything ready. If a certain gasket is what I need to make this work that is fine. I am open to any suggestions.
Last edited by obrien24; 02-14-2005 at 05:57 PM.