Finally!
#1
TECH Apprentice
Thread Starter
iTrader: (12)
Join Date: Oct 2004
Location: Paved road in OK
Posts: 317
Likes: 0
Received 0 Likes
on
0 Posts
Finally!
I finally figured out what length pushrod is needed for TSP Torquer cam, PP LS6 heads, and Patriot Shaft mount rockers, and Comp R lifters, Drum roll..................7.150
I searched i don't know how many times, talked to Gunnar at Patriot and he told me 7.200, I had already bought 7.400 from TSP, they were kind enough to exchange them for the 7.200, I just got done trying these out and they are just a hair off of the pedastal with the adjuster backed all the way out. I don't know if the Comp R lifters cause any difference in height, but hopefully TSP will allow me to yet again exchange these pushrods for the 7.150. Knowing what I know now, I would have bought the pushrod length checker and saved myself alot of time and trouble. THis was my first H/C swap and I have learned a ton. Do not always trust what someone else says, double check it yourself, and just because it is cheaper doesent mean it is better, Good customer service is priceless! That is all
I searched i don't know how many times, talked to Gunnar at Patriot and he told me 7.200, I had already bought 7.400 from TSP, they were kind enough to exchange them for the 7.200, I just got done trying these out and they are just a hair off of the pedastal with the adjuster backed all the way out. I don't know if the Comp R lifters cause any difference in height, but hopefully TSP will allow me to yet again exchange these pushrods for the 7.150. Knowing what I know now, I would have bought the pushrod length checker and saved myself alot of time and trouble. THis was my first H/C swap and I have learned a ton. Do not always trust what someone else says, double check it yourself, and just because it is cheaper doesent mean it is better, Good customer service is priceless! That is all