Michael Ozorowsky

iTrader: (1)

What kind of fluid to put in master cylinder. Also how do I drain? I'm finishing up my A4 to M6 conversion, and want to make sure that hydraulic fluid is good, clean and bubble free.

Also Right now I have pedals installed, master cylinder (Have slave, but don't have hooked up at moment) I have the manual flywheel in car, and Pressureplate/clutch installed. No transmission. If I start car right now, will anything bad happen? Sorry to be dumb, I just don't know.

Michael Ozorowsky

iTrader: (1)

ttt any help?

camrsz

iTrader: (4)

Brake fluid is most commonly used for clutches. You should be ok to start it. Why do you want to?

Michael Ozorowsky

iTrader: (1)

Haven't started her in 2 months. been waiting on money for parts I just want to hear her purrr. Also what kind of brake fluid? Coastal Dot 3?

camrsz

iTrader: (4)

that will work. Get something with the highest boiling point you can find

silverbeast

iTrader: (16)

someone said to use willwood high temp brake fliud. i picked up a bottle for 20.00 but i havent put it in yet.

calhoon

iTrader: (6)

I would be concerned about starting the engine without careful support at the rear. With the trans absent there is no "Third" mount for the engine.

Michael Ozorowsky

iTrader: (1)

Alright. I've actually just decided to wait 'til I get transmission in. I just HOPE everything goes smooth. I Just have to figure out exactly where to wire this reverse lockout and I'm good to go.