Installing 4.10's
07-05-2005, 08:42 PM
#1
TECH Fanatic
Thread Starter
iTrader: (1)
Join Date: Feb 2003
Location: DOWKNEE, CA.
Posts: 1,000
Likes: 0
Received 0 Likes
on
0 Posts
Installing 4.10's What's up guys! My Motive 4.10 gears have arrived.I have a 2001 SS M6 w/ traction control. Is there anything I need to do or buy other than fluids to make the installation simple. Any comments or ideas? Thanx!
07-05-2005, 09:11 PM
#2
12 Second Club
iTrader: (21)
Join Date: May 2005
Location: Indiana
Posts: 813
Likes: 0
Received 0 Likes
on
0 Posts
a impact gun helps alot. if you dont have one go buy 1. remember to take the abs sensors off the rear so u can push the axles in enuff to get the keepers out. my uncle (heymoej) and i have been gettin pretty quick with gear changes. about 2 hrs and your ready to roll.
07-10-2005, 11:19 PM
#5
TECH Fanatic
iTrader: (22)
Join Date: Dec 2004
Location: Fishers, IN
Posts: 1,232
Likes: 0
Received 0 Likes
on
0 Posts
Not sure about the torsen posi, but on the others you can just remove the pin in the center of the unit and push the axles towards the inside and the c-clips will just fall right out. Just make sure to get your backlash and tooth pattern correct or you might as well be throwing your money away. Not sure if you have purchased a gear install kit or not but you will need one of those, or at lease the shims and crush sleeve from it if your bearings a races swap ok.