A few pics of my bracket for solenoids...
#1
Restricted User
Thread Starter
iTrader: (9)
Join Date: Apr 2004
Posts: 2,692
Likes: 0
Received 0 Likes
on
0 Posts
A few pics of my bracket for solenoids...
I have the power ring but dont have the bracket that came with the kit as it was acquired seperately. So, as opposed to ordering one up and a little motivation from Nitro DAVE, I made my own with my favorite manufacturer in mind as the motif. Enjoy:
Thanks Dave !
Thanks Dave !
#6
Restricted User
Thread Starter
iTrader: (9)
Join Date: Apr 2004
Posts: 2,692
Likes: 0
Received 0 Likes
on
0 Posts
Thanks LETZ, Dave and Robert ! I think the TNT kit is nicely done but with the bracket, ring, solenoids and lines all in the area of the Throttle Body...it ends up cluttered there.
Dave - ya, it didn't take me long after we spoke. I got on the web and searched for a bowtie logo, threw it in Photoshop to enlarge it to almost 3"X5", printed it out then cut it out and traced onto the aluminum. Snipped away here and there, made a basic 90' bend bracket with tabs to reinforce it and drilled them both for the 'noids.
Robert - the "finishing" on the bowtie was done with a dremmel. I took a very small round sander with fine grit and went around the piece. It was already mostly rounded from the template, I just completed it.
If anyone wants one, let me know and i'll make it for the cost of the materials.
Dave - ya, it didn't take me long after we spoke. I got on the web and searched for a bowtie logo, threw it in Photoshop to enlarge it to almost 3"X5", printed it out then cut it out and traced onto the aluminum. Snipped away here and there, made a basic 90' bend bracket with tabs to reinforce it and drilled them both for the 'noids.
Robert - the "finishing" on the bowtie was done with a dremmel. I took a very small round sander with fine grit and went around the piece. It was already mostly rounded from the template, I just completed it.
If anyone wants one, let me know and i'll make it for the cost of the materials.