LS1TECH - Camaro and Firebird Forum Discussion

Generation III External Engine LS1 | LS6 | Bolt-Ons | Intakes | Exhaust | Ignition | Accessories
Sponsored by:
Sponsored by:

MAP sensor leak?

Thread Tools
 
Search this Thread
 
Old 01-21-2006, 11:41 AM
  #1  
12 Second Club
Thread Starter
iTrader: (1)
 
smask04C5's Avatar
 
Join Date: Dec 2004
Location: Winter Haven, Fl.
Posts: 607
Likes: 0
Received 1 Like on 1 Post

Default MAP sensor leak?
I recently installed a fast90/nw 90 on vette in sig. Found an apparent induction leak at the map. Question is, anyone have any good ideas how to seal this sensor to fast intake? I have a new viton marine seal for the map nipple, but wondering if a dollop of ultra black on the sensor body would hurt anything. Thanks for the replies.
smask04C5 is offline  
Reply Like
Old 01-21-2006, 11:59 AM
  #2  
TECH Senior Member
iTrader: (6)
 
WILWAXU's Avatar
 
Join Date: Nov 2001
Location: League City, TX
Posts: 14,378
Likes: 0
Received 1 Like on 1 Post

Default
I would try some ultra black. If you let is setup before starting, can't think of anything it could hurt on that side of the motor.
WILWAXU is offline  
Reply Like
Old 01-21-2006, 12:00 PM
  #3  
TECH Addict
iTrader: (2)
 
slowpoke96z28's Avatar
 
Join Date: May 2005
Location: cedar hill, tx
Posts: 2,099
Received 9 Likes on 6 Posts

Default
no it wont hurt. just give it a couple hours to cure before you start it.
slowpoke96z28 is offline  
Reply Like
Old 01-21-2006, 01:49 PM
  #4  
12 Second Club
Thread Starter
iTrader: (1)
 
smask04C5's Avatar
 
Join Date: Dec 2004
Location: Winter Haven, Fl.
Posts: 607
Likes: 0
Received 1 Like on 1 Post

Default
10-4 thanks for the response
smask04C5 is offline  
Reply Like
Tags
Back to Subforum
Generation III External Engine
View Next Unread
Homemade Smooth Bellows (Fernco) Sizes?




Advanced Search

All times are GMT -5. The time now is 11:25 PM.