cruise control not working
02-22-2006, 10:37 AM
#1
On The Tree
Thread Starter
Join Date: Jun 2004
Location: Michigan
Posts: 140
Likes: 0
Received 0 Likes
on
0 Posts
cruise control question The cruise on my new Z28 doesn't work. I checked the fuse under the hood and it was good. Is there anything else I should be checking? Will I have to have it hooked up to a diagnostic computer? Is there anything that is known to be a problem in the cruise control system?
thanks,
pmh
thanks,
pmh
02-22-2006, 11:24 AM
#3
On The Tree
Thread Starter
Join Date: Jun 2004
Location: Michigan
Posts: 140
Likes: 0
Received 0 Likes
on
0 Posts
both of the cable that are attached at the throttle body are hooked up and apear to work. Is there another place that they attach to? Also where is the CC module? I heard that this could be the issue.
pmh
pmh
02-23-2006, 07:03 AM
#5
TECH Enthusiast
iTrader: (9)
Join Date: Aug 2003
Location: T.H. Indiana
Posts: 588
Likes: 0
Received 0 Likes
on
0 Posts
If you look on the driver side, there's a couple of ground wires that is bolted to the frame (around the area of the AIR pump). One is a copper wire that runs to the block, the other one is a small black wire. That black wire is somehow hooked into the cruise control and if doesn't have a good contact on it, cruise control will not work. I know b/c after a cam swap, I overlooked this wire and for 2 months couldn't figure out why my cc wasn't working. One day I saw it dangling while under the car, fixed it and my cc worked again.