Balance Problems With Re-surfaced Flywheel??
#1
Teching In
Thread Starter
Join Date: Feb 2006
Location: SoCal
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
Balance Problems With Re-surfaced Flywheel??
I had my flywheel surfaced for my new clutch & press. plate. I have just heard that a poss. balance prob could occur, anybody have this problem? any suggestions? I already re-installed in my car, but have not fired this up for 1st time yet. Did I screw up? I hope I don't need to pull it back out. Thanks all
#3
Teching In
Thread Starter
Join Date: Feb 2006
Location: SoCal
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
Thanks Starz, makes sense to me too. I guess I'll cross my fingers on this one since I already have it in the car, but next time I'll have it checked for 0 balance 1st.
#4
Yeah I know many people who had their OE flywheels cut and had zero problems, just make sure they dont cut too much off, You will be fine as long as too much isnt taken off