brad8266

iTrader: (23)

I am doing an LS6 intake swap soon and figured while im at it I would just replace my injectors with the Holley 50Lb'ers that I have laying around.

These injectors will idle and run OK provided that my IFR, offset and associated tables are redone right? I only have boltons for mods, and the wet shot, but that should have no affect. I was just concerned that it may run rough because they will barely be using any duty cycle.

Also does anyone have the values for the tables for using 50lb'ers?

theblur98ss

iTrader: (71)

That sounds like an aweful big injector for your limited mods. I think you would have been better off leaving your stockers in there.

brad8266

iTrader: (23)

Probably, but I do have plans that will require a larger injector in the future. Just figured i might put them on and try them out.