LS1TECH - Camaro and Firebird Forum Discussion

Manual Transmission T56 | T5 | MN12 | Clutches | Hydraulics | Shifters

Need help fast.

Thread Tools
 
Search this Thread
 
Old 08-08-2006, 02:56 PM
  #1  
TECH Fanatic
Thread Starter
iTrader: (19)
 
JD_Z28's Avatar
 
Join Date: Jul 2005
Location: Arizona
Posts: 1,166
Likes: 0
Received 1 Like on 1 Post

Default Need help fast.
When doing the viper conversion, what needs to be done to the drive shaft besides the 1350 yoke. Do the u-joints need changed.
JD_Z28 is offline  
Reply Like
Old 08-08-2006, 05:53 PM
  #2  
TECH Addict
iTrader: (39)
 
NVR_SPDS's Avatar
 
Join Date: Aug 2003
Location: Virginia
Posts: 2,129
Likes: 0
Received 3 Likes on 3 Posts

Default
Well, you obviously need the front joint, but you can replace the rear one if youd like.
NVR_SPDS is offline  
Reply Like
Old 08-08-2006, 06:04 PM
  #3  
Kleeborp the Moderator™
iTrader: (11)
 
MeentSS02's Avatar
 
Join Date: Mar 2004
Location: Dayton, OH
Posts: 10,316
Likes: 0
Received 3 Likes on 3 Posts

Default
If it is an actual Viper output shaft, the whole yoke would have to be changed...but that isn't something that can be done "fast"
MeentSS02 is offline  
Reply Like
Old 08-08-2006, 06:24 PM
  #4  
TECH Fanatic
Thread Starter
iTrader: (19)
 
JD_Z28's Avatar
 
Join Date: Jul 2005
Location: Arizona
Posts: 1,166
Likes: 0
Received 1 Like on 1 Post

Default
Originally Posted by MeentSS02
If it is an actual Viper output shaft, the whole yoke would have to be changed...but that isn't something that can be done "fast"
I have the yoke already, I wasn't sure if there was anything else needed. I found out that the u joints need changed also.
JD_Z28 is offline  
Reply Like
Back to Subforum
Manual Transmission
View Next Unread
Anybody going to NvsS 6speed




Advanced Search

All times are GMT -5. The time now is 02:02 PM.