ace68

iTrader: (15)

I am installing a vic jr intake but I need an elbow. I have seen the welded and cast but can't seen to find where they can be had. I searched but haven't had any luck with finding where they are bought.

Z06PSI

iTrader: (33)

Down the right hand side there is a place called

www.intakeelbows.com

ace68

iTrader: (15)

Opps I missed that I was checking sights that I bought from before and some of the turbo sights. THose are some nice pieces for sure. What about the cast elbows I have seen where are those sold?

ABeasst

iTrader: (5)

I have one from intakeelbows.com I'm wanting to sell. It was bungs welded into it and is for a 90mm TB. Let me know if interested.

ace68

iTrader: (15)

Would the round cast elbow flow better than the sheetmetal one? Still can't find the cast one anywhere. did some searches found a place, Precision Turbo metioned in a post but didn't see one listed on there sight.

ABeasst

iTrader: (5)

wilsonmanifolds.com sells the cast ones.

ace68

iTrader: (15)

thanks man,

I like the looks of the welded one but it seems the cast will flow better but then it's going into the square boar of the intake so I don't know.

ANyone have an opinion on the flow between the two types? Will it matter much on a turbo setup? I have a feeling the cast round elbow will work just a tad better while crusing.

ace68

iTrader: (15)

I think I.m going to go with the cast elbow; unless I decide to get the welded one first

ace68

iTrader: (15)

I am going with the cast thanks for the offer ABeasst.



I think it will fit my application better, I want to thank everyone for there input it really really helped