Going to 4:10's... Any special tools needed?
02-26-2007, 08:09 AM
#1
Launching!
Thread Starter
Join Date: Mar 2004
Location: Austin
Posts: 290
Likes: 0
Received 0 Likes
on
0 Posts
Going to 4:10's... Any special tools needed? I'm going to be swapping my gears to 4:10's but never done a gear swap before. Do I need the whole ratech install kit with new bearings, gaskets or can i just reuse the old ones?
Is there a "how-to" on this?
Is there a "how-to" on this?
02-26-2007, 08:43 AM
#2
Holy crap, who knew you could find helpful info in the FAQ at the top of the page?
https://ls1tech.com/forums/gears-axles/412366-rear-end-faq.html #5
https://ls1tech.com/forums/gears-axles/412366-rear-end-faq.html #5