BoomerSooner

I changed my intake to a LS-6 intake, fired it up, and got a SES light p342 camshaft position circuit low input. Im looking in the detailed diagnostic section, and my question is how do you change the sensor, and would it cause your tach not to work also? I have the intake pulled forward, exposing the sensor, its held with 1 bolt, but i cant get it to budge and come out, I sure would love some input on this as i am tired of working on this dang thing, these cars are fun but a pain to work on.


99 M-6 T/A
all bolt ons 4:10's
stealth II MTI cam

2xLS1

iTrader: (25)

I'm guessing you pinched the wires putting the manifold on. I've seen it done before. CP sensors don't just go bad changing the intake manifold.

slmdLS1

iTrader: (8)

P0342 here also. i switched motors and went with a FAST swapped on outside the car, so i didnt pinch any wires. any other solution to a CPS low voltage issue?