ConfusedGarage

iTrader: (2)

I am about to install my new Tex, slave, and pilot bearing. Should I replace my master or just do the drill mod and flush the current one? I am a little poor now since the clutch purchase, but I like to do things right. The car is a 99 with 50,000 miles.

If I want to replace it, where is the best place and what do they cost...dealer?

Thanks

JonB

iTrader: (3)

It would be chea insurance to replace it but is not a must. I sent you a PM on the best place go get a new master since the site is not a sponsor.

connexion2005

iTrader: (49)

not a must. really if its fine now I wouldnt worry to much about since you won't have to drop the tranny to do it even if it goes out later. The regular replacements run around $100. I did mine since it blew at 89k.