Yo, Eric - the ULTIMATE road race Vette mod
03-23-2007, 07:44 AM
#1
10 Second Club
Thread Starter
iTrader: (4)
Join Date: Feb 2004
Location: Marysville, WA
Posts: 9,448
Likes: 0
Received 0 Likes
on
0 Posts
Yo, Eric - the ULTIMATE road race Vette mod So, you wanna make some changes to your Z, eh? I think I found the car to model yours after (& where to take it to have the work done). 
https://ls1tech.com/forums/showthrea...17#post6708317
https://ls1tech.com/forums/showthrea...17#post6708317
03-26-2007, 11:56 PM
#3
TECH Fanatic
Thanks Mark! Your just like my wife thinking of ways to spend money. However, unlike her you are looking to spend on ME! I like those fender flares but it would look a lot better with deep dish wheels.
03-27-2007, 07:21 AM
#4
10 Second Club
Thread Starter
iTrader: (4)
Join Date: Feb 2004
Location: Marysville, WA
Posts: 9,448
Likes: 0
Received 0 Likes
on
0 Posts
Should be fairly cheap to have stubby axle shafts made for a vette so you can run deep-dished wheels. That WOULD look hot! 
I thought this car was pretty much what you had talked about doing. Then you Perry & Paul can go do some serious corner carving. And Bob @ EPP is waiting for your call. Tell him I sent you & you'll get the special rate (cost + 500%)
I thought this car was pretty much what you had talked about doing. Then you Perry & Paul can go do some serious corner carving. And Bob @ EPP is waiting for your call. Tell him I sent you & you'll get the special rate (cost + 500%)