02SOMWS6

iTrader: (6)

I have a set of ported 241 heads that are decked 30 and a stock bottom end. I'm going to check p to v but was wondering if anyone knew what the biggest cam I could go with. I make 452 rwhp now with a 12 bolt and a steel drive shaft. I'm ready to move up to a bigger cam but I don't want to flycut our junk cast pistons and there's only 1,500 miles on the bottom end so I'm not sure that I want to tear it apart to go with a set of mahle pistons .

02SOMWS6

iTrader: (6)

I guess no one has heads that are decked 30 with a big cam