bent pushrods
#1
12 Second Club
Thread Starter
iTrader: (6)
Join Date: Aug 2006
Location: Bradley IL
Posts: 295
Likes: 0
Received 0 Likes
on
0 Posts
bent pushrods
UMM... I have been taking apart my car to do a cam swap (ms3) and i just took out my pushrods and 2 of them are slightly bent and one of them was pretty bad... is this something I should seriously be worried about? The car ran great? It has about 103K. I am getting new pushrods but... Just wanting everyones input. It kinda freaked me out when I saw them... lol I was like " umm what the hell!? What if it slipped from underneath the rocker arm!? Could it have been from a previous owner overtightening the rocker arm? I dont think this would be the case because These are non adjustable... which Were surprisingly, a bitch to break loose. (esp. the last two on the pass side).
Just looking for some input guys.... anything you can tell me is much appreciated!
Thanks in advance...
-Andrew
Just looking for some input guys.... anything you can tell me is much appreciated!
Thanks in advance...
-Andrew
#3
12 Second Club
Thread Starter
iTrader: (6)
Join Date: Aug 2006
Location: Bradley IL
Posts: 295
Likes: 0
Received 0 Likes
on
0 Posts
I never overreved my car though... and the highest I shift at is 5500. And I hear guys on here changing their limiter on stock ls1's to shift at like 6300 with no problems? Haha well I dont really care anyways b/c I am getting new pushrods w/ my package so I think it will be fine . I guess you guys will know in a couple hours hopefully My package is "out for delivery" so I should get it pretty soon....( I may be on here cursing up a storm... you'll know what happend then) haha
Well thanks for the info....
-Andrew
Well thanks for the info....
-Andrew
#4
TECH Enthusiast
iTrader: (16)
Join Date: Nov 2004
Location: Birmingham, AL
Posts: 577
Likes: 0
Received 0 Likes
on
0 Posts
Alot of people find out that their pushrods are slightly bent, from either the previous owner or themselves over reving the motor like on a 2-3-2 accidental shift. Btw, I reved my stock cam to 6200 many many times, all of my pushrods were straight
#6
Staging Lane
Join Date: Feb 2007
Location: Long Beach CA
Posts: 78
Likes: 0
Received 0 Likes
on
0 Posts
Mine, bent/broke randomly, i say randomly because at no point since ive had teh car remember over-revving or anything liek that....might have been previous owner but iono, when i took off my valve covers...look what i saw...
have no idea what caused it, was crusin home just doin like 40 on the street...all the sudden SES light blinking.... turns out it was a P0304 missfire....so we take off the valve cover and do some inspecting and this is what we found....anyone know hte chances of bending valves with that happening? im almost certain i have a few bent valves...
have no idea what caused it, was crusin home just doin like 40 on the street...all the sudden SES light blinking.... turns out it was a P0304 missfire....so we take off the valve cover and do some inspecting and this is what we found....anyone know hte chances of bending valves with that happening? im almost certain i have a few bent valves...