67 RS/SS close to completion
#1
Teching In
Thread Starter
Join Date: Dec 2006
Location: Yorktown, VA
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
67 RS/SS close to completion
Well, hopefully Uncle Sam stays off my *** for just a little bit so I can finish...Hopefully sometime before the end of summer...I'll try to put up a post with a link to a pic site and put more pics up...Some pics added here, Left click on them to expand.
Last edited by dwoytanis; 05-07-2007 at 10:04 AM.
#4
Teching In
Thread Starter
Join Date: Dec 2006
Location: Yorktown, VA
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Engine is a 11.5:1 SBC 1989 Roller Cam block, Callies Crank( 220 bucks on E Bay), GM PM Rods, Keith Black forged +12 CC pistons ( added 2.3 points to the compression), Harland Sharp roller rockers ( 1.7:1 intake,1.6:1 exh ), Edelbrock ETEC 200 heads, GM beehive springs, Comp Cams 236/244 112 .580 I/E, Mighty Demon 750, Hooker Super comps 1 3/4 primaries, 35", dumping to 24" chambered tubes with no tail pipes ( read as really loud and raspy )Dual Mallory 6AL boxes, Mallory Mech adv, Art Car Pro Strip TH 350 Tranny, 3 extra clutch packs, forged input shaft, straight cut gears, Edge Racing 3500 Stall converter, Sttrange Drive Shaft, Strange forged Trans Yoke, Strange forged 1350 U joints, Strange S60 rear with 3:93 gears, Full Detroit locker, 35 spline S/T axles.
Basically built it to look original ( exception of color) on the outside, Stock interior, but have the heart of a Cheetah and the power of an elephant.
Basically built it to look original ( exception of color) on the outside, Stock interior, but have the heart of a Cheetah and the power of an elephant.