ri5e

On the back of the LS1 intake manifold, there is a big black plug with 3 ports (HVAC/MAP Sensor/Brake Booster). I would like to know where I can purchase a block off plate to block this? I am going to relocate these ports elsewhere. The only reason why I am asking is because the MAP Sensor/Brake Booster nipple are touching my firewall (1993 RX-7) and preventing me from mounting the LS1 intake manifold. I just need 1/4 inch of clearance and I'm good to go and I would rather not bang up my firewall.

datboibrad

iTrader: (1)

i would recheck your setup. this swap is far from rare and ive never heard of anyone having the issue your describing. to my knowledge however i havent seen anything put out to remedy a solution.

Kamin

im interested in this too, i want my engine as far back as possible but dont want to have to drop the engine to get to the MAP sensor if i ever have an issue.